The transmission part of the horizontal plow blade mixer is composed of components such as the motor, cycloidal pinwheel reducer, coupling, and plow blade shaft. The horizontal cylindrical body is used for holding materials. Several holes are opened on the cylinder body for feeding and discharging materials as well as for observation. The plow blade shaft support seat is fixed on the cover plates at both ends of the cylinder. The plough blade assembly consists of a plough blade, a plough blade arm and a main shaft. The plough blade is installed on the main shaft by the plough blade arm and is made into a halve structure for easy disassembly and assembly. The flying knife assembly consists of multiple flying knives, which are directly driven by a motor and installed on the side of the cylinder. The discharge valve is installed at the bottom of the cylinder (except for continuous discharge), and is used to close and discharge the material. The liquid spraying device of the mixer is fixed above the cylinder, and the nozzles are agricultural spray heads, which can spray well.

  After the horizontal plow blade mixer is started, the plow blades are driven to rotate by the plow blade shaft, causing the materials to flow circumferentially along the radial direction of the cylinder, and at the same time, the materials are thrown out along the normal directions of both sides of the plow blades. When the thrown and circumferentially turbulent material flows through the flying knife assembly, it is scattered by the high-speed rotating flying knives. Under the combined action of the above-mentioned plow knife and flying knife, the materials are continuously stacked and diffused, achieving uniform mixing in a short time with high mixing accuracy. For materials that require solid-liquid mixing, the mixed liquid is evenly sprayed onto the moving materials in the cylinder through the liquid spraying device.

  Many industries need to complete production tasks through the mixing and processing of materials. Therefore, in these processing units, attention should be paid to the proportion and content of raw materials, as well as the mixing situation of materials, etc. Nowadays, horizontal plow blade mixers are widely used in many workplaces. During operation, this equipment can accelerate the processing speed and also ensure the uniform mixing of materials.

  Then, during the use of the horizontal plow blade mixer, will there be any impact on the raw materials themselves? During the process of material mixing, physical and chemical reactions mainly occur. If the materials can be mixed evenly, the ideal production goal can be achieved after the processing is completed.

  In fact, when using a horizontal plow blade mixer to mix materials, there will be no wear or squeezing on the materials. The materials will not change before being put into the equipment and after the processing is completed. Therefore, you can rest assured during the processing and production with the equipment. Additionally, using the mixing equipment for production and processing will not affect heat-sensitive materials. There is no need to worry about overheating during the material mixing stage.